Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Los Feliz, CA
Gate access control is the call we get most from Los Feliz homeowners, and the reason usually sits in the hills. The Oaks streets and slopes below Griffith Park put automated gates through conditions flatland neighborhoods never see: steep driveways that force operators to work against grade, Santa Ana wind gusts that knock photo-eyes out of alignment, and LAFD fire-code requirements that demand a Knox key switch on every automated entry. Call (213) 674-2473 and we’ll send a technician who already knows what these gates are up against.
Why Los Feliz Homes Are Different
Los Feliz is dense with 1920s through 1940s Spanish Colonial Revival, Mediterranean, and Craftsman homes, and a surprising number still have their original ornamental wrought iron entry gates. Those gates were built with pivot hardware that’s now 80 to 100 years old: worn hinge pins, surface rust, and gate leaves that sag just enough to drag on the driveway. The fix is usually restoration and sympathetic fabrication, not a teardown and replacement. Up in the Los Feliz Oaks and along the streets above Franklin Avenue, the situation changes again. Those larger hillside estates often carry custom-fabricated heavy steel gates on steep lots with non-standard post configurations. And every automated driveway gate in the Very High Fire Hazard Severity Zone must include an LAFD-approved Knox key switch or emergency-access override. That’s a compliance requirement enforced here that most flatland neighborhoods in the basin never deal with. When we work on a Los Feliz gate, we’re accounting for fire code, slope, and 90-year-old iron in the same visit.
Our Main Los Feliz Services
These are the three pages Los Feliz homeowners use most, each written around the specific conditions we find in this city.
Gate Repair in Los Feliz
Gate repair in Los Feliz usually starts with a hinge or a latch that’s been stressed by wind and age. On the original wrought iron gates common here, we’re often repairing what’s already there: replacing a worn hinge pin, re-seating a sagging leaf, or reinforcing a post that’s leaned in loose hillside soil. On automated gates, we’re correcting operator settings that previous installers set wrong for the slope. Read the full breakdown on our Gate Repair in Los Feliz page, including what specific failures cost here.
Gate Installation in Los Feliz
New gate installation in Los Feliz has to respect the terrain before anything else. On steep, curved driveways in the Oaks, a standard inward-swinging gate will arc directly into rising grade and bind on concrete. We see that mismatch often, and it means choosing the right swing direction and operator from the start. See what a full Los Feliz installation involves on our Gate Installation in Los Feliz page.
Gate Motor & Opener in Los Feliz
Motor and opener work here skews toward slope-rated operators and anti-rollback hardware that flatland homes don’t need. We service LiftMaster, DoorKing, Viking, Linear, FAAC, BFT, Ghost Controls, Elite, and Mighty Mule, so the motor already on your property is usually repairable rather than replaceable. Our Gate Motor & Opener in Los Feliz page covers the common failures and what they cost to fix here.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in Los Feliz
Gate access control in Los Feliz is shaped by fire code as much as by convenience. Every automated driveway gate in the hillside Very High Fire Hazard Severity Zone must carry an LAFD-approved Knox key switch or emergency-access override, and older 1920s-era properties often have wiring and entry hardware that predates that requirement entirely. We handle the full system, from keypads and phone entry to video intercoms and card readers, and we do it while keeping the fire department’s access path intact. This is the work Adrian Vance brought over from commercial access-control sites starting in 2014, now applied to Los Feliz driveways. For the complete scope of what we service, see Gate Access Control.
Keypad Entry
Signs you need it
The keypad is unresponsive, works intermittently after rain, or has buttons worn blank from years of use.
What it costs in Los Feliz
Keypad replacement or installation in Los Feliz typically runs $220-$410 per unit, including programming.
How we do it
We pull the old unit, mount the new keypad, wire it into the existing operator, program the codes, and photograph the finished setup for your job record.
Phone Entry
Signs you need it
Visitors press the call button and get dead air, or the system rings but can’t trigger the gate from the other line.
What it costs in Los Feliz
Phone entry systems in Los Feliz run $500-$1,400 installed, with programming and a functional test on the actual gate.
How we do it
We install or replace the phone entry unit, wire it to the gate operator, program the call queue, and test the open command from a live phone before we leave.
Video Intercom
Signs you need it
The screen stays black, audio cuts out, or the camera feeds a blurry image at night.
What it costs in Los Feliz
Video intercom installation in Los Feliz typically runs $800-$2,000, depending on camera count and monitor placement.
How we do it
We mount the camera, run the feed to the indoor monitor, configure the app or handset, and verify two-way audio and gate release from every station.
What Gate Access Control Costs in Los Feliz
| Item | Typical range in Los Feliz |
|---|---|
| Keypad entry (installed, programmed) | $220-$410 |
| Phone entry system | $500-$1,400 |
| Video intercom | $800-$2,000 |
Can you add a Knox key switch to an existing automatic gate in Los Feliz?
Yes. We install LAFD-approved Knox key switches on existing operators throughout the Los Feliz hillside fire zone, wired as an override that works even if primary power to the gate fails. Call (213) 674-2473 for a written quote.
Do Los Feliz HOAs require a specific access control system?
Some do, especially gated enclaves in the upper Oaks streets. We work with HOA-specified hardware and document every setting in writing, so boards can verify compliance without reopening the panel.
Gate Parts & Welding in Los Feliz
Gate parts and welding in Los Feliz often means saving the original iron rather than buying new. The 1920s-1940s homes here carry ornamental wrought iron that was hand-forged, and when a hinge cracks or a post leans, a sympathetic repair keeps the gate looking right for the house. We fabricate and weld on site when the part is gone, and we carry common replacement parts for the gate operators already on these hillside properties. See Gate Parts & Welding for the full repair scope.
Hinge Replacement
Signs you need it
The gate leaf sags, scrapes the driveway, or swings with a visible wobble around the hinge pin.
What it costs in Los Feliz
Hinge replacement in Los Feliz normally runs $150-$400 per hinge, including the part and labor.
How we do it
We support the gate leaf, cut or unbolt the failed hinge, weld or bolt the new one in place, and photograph the final alignment.
Post Replacement
Signs you need it
The gate post leans, shifts when you push the gate, or shows a widening gap between post and gate at the latch.
What it costs in Los Feliz
Post replacement in Los Feliz runs $500-$1,500 depending on concrete depth, post size, and whether we’re resetting or pouring new footings.
How we do it
We brace the gate, cut the old post free, set the new post in concrete, rehang the gate to true, and record the finished install with photos.
Custom Welding
Signs you need it
A cracked rail, a snapped hinge bracket, or a broken spear point shows bare metal and won’t hold with a bolt-on repair.
What it costs in Los Feliz
Custom welding and fabrication in Los Feliz is priced by the job after we see the gate, with the written quote delivered before any work starts.
How we do it
We grind the break clean, weld the piece in place or fabricate a replacement section, dress the weld, and photograph the finished repair for the job record.
What Gate Parts & Welding Costs in Los Feliz
| Item | Typical range in Los Feliz |
|---|---|
| Hinge replacement (per hinge) | $150-$400 |
| Post replacement | $500-$1,500 |
| Custom welding & fabrication | Written quote, job-specific |
Can you match the original ironwork on a 1930s Los Feliz gate?
Yes. We match section profile, joinery style, and patina as closely as the remaining metal allows, then photograph the finished weld next to the original for comparison before we leave.
Do you replace gate rollers on Los Feliz driveway gates?
Yes. We replace worn or seized rollers on rolling and sliding gates and set the track alignment so the repaired gate rolls under its own weight. Call (213) 674-2473 for an exact quote.
Brands We Service in Los Feliz
We service nine gate-automation brands in Los Feliz, so the motor already on your driveway is usually repairable rather than replaceable. DoorKing is common on the larger hillside estates above Franklin, Viking and Ghost Controls show up on many orchard-style properties in the Oaks, and Linear appears across the neighborhoods north of Los Feliz Boulevard. See our brands for the full list and our parts-stocking approach.
Pricing for Gate Repair in Los Feliz, CA
| Service | Typical range in Los Feliz |
|---|---|
| Gate repair service visit (diagnostic included) | $85-$170 |
| Keypad entry | $220-$410 |
| Phone entry system | $500-$1,400 |
| Video intercom | $800-$2,000 |
| Hinge replacement (per hinge) | $150-$400 |
| Post replacement | $500-$1,500 |
| Custom welding & fabrication | Written quote, job-specific |
| Swing gate motor replacement | $700-$1,600 |
| Sliding gate motor replacement | $950-$2,300 |
| Operator circuit board replacement | $230-$560 |
| Photo-eye / loop detector | $150-$350 |
Two things push prices up in Los Feliz more than anything else. Hillside post work means deeper concrete and often a crew, because loose soil on slopes won’t hold a standard footing the way flat lots will. And the ornamental iron on older homes doesn’t have off-the-shelf replacement parts, so any match work is measured, cut, and welded on site. Every price above is set in writing and handed over before any work begins; what you’re quoted is what the job costs.
Neighborhoods We Serve in Los Feliz
We cover the whole city, from the flat streets below Franklin to the winding drives up in the hills. Response time in Los Feliz is usually 1-2 hours from the call.
- Los Feliz Oaks
- Los Feliz Village
- Franklin Hills
- Laughlin Park
- Vermont Square / Los Feliz border
Service Area - Cities Near Los Feliz
Our crews also serve the surrounding metro. If you’re in Los Angeles, CA beyond the Los Feliz boundary, or west in Culver City, CA, Venice, CA, or Santa Monica, CA, the same written-price and photo-record process applies. Scheduling is coordinated from our Los Angeles office; the crew that arrives is local.
Serving Los Feliz, CA - Our Local Coverage Area
We’re based in the Los Feliz area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Los Feliz
We aim for a 1-2 hour arrival anywhere in Los Feliz, including the hillside streets. A live person answers the phone 24/7, so you’ll know who’s coming and when before we dispatch.
Most repairs don’t need a permit. New installations and any work inside the fire zone may, particularly when the gate is automated. We’ll confirm applicable requirements before any job is priced.
We provide a written scope, written price, and a photo record of everything installed and adjusted. That documentation is usually what HOA boards and architectural committees need to sign off.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Los Feliz Customers Say
"Good work on a long driveway gate. Arrived when they said, finished when they said."
- Sofia E."They installed the opener and left me a diagram of the wiring and the limit settings. When I needed a second remote programmed I could do it myself."
- Nadine C."The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H.